J Wrist Surg 2013; 02(04): 306-314
DOI: 10.1055/s-0033-1359307
Special Focus Section: New Horizons in Wrist Surgery
Thieme Medical Publishers 333 Seventh Avenue, New York, NY 10001, USA.

Accuracy of 3D Virtual Planning of Corrective Osteotomies of the Distal Radius

Filip Stockmans
1   KULeuven Campus KULAK, Kortrijk, Belgium
2   Department of Orthopedic Surgery at AZ Groeninge Hospital, Kortrijk, Belgium
,
Marleen Dezillie
2   Department of Orthopedic Surgery at AZ Groeninge Hospital, Kortrijk, Belgium
,
Jeroen Vanhaecke
2   Department of Orthopedic Surgery at AZ Groeninge Hospital, Kortrijk, Belgium
› Author Affiliations
Further Information

Publication History

Publication Date:
08 November 2013 (online)

Abstract

Corrective osteotomies of the distal radius for symptomatic malunion are time-tested procedures that rely on accurate corrections. Patients with combined intra- and extra-articular malunions present a challenging deformity. Virtual planning and patient-specific instruments (PSIs) to transfer the planning into the operating room have been used both to simplify the surgery and to make it more accurate. This report focuses on the clinically achieved accuracy in four patients treated between 2008 and 2012 with virtual planning and PSIs for a combined intra- and extraarticular malunion of the distal radius. The accuracy of the correction is quantified by comparing the virtual three-dimensional (3D) planning model with the postoperative 3D bone model. For the extraarticular malunion the 3D volar tilt, 3D radial inclination and 3D ulnar variance are measured. The volar tilt is undercorrected in all cases with an average of –6 ± 6°. The average difference between the postoperative and planned 3D radial inclination was –1 ± 5°. The average difference between the postoperative and planned 3D ulnar variances is 0 ± 1 mm. For the evaluation of the intraarticular malunion, both the arc method of measurement and distance map measurement are used. The average postoperative maximum gap is 2.1 ± 0.9 mm. The average maximum postoperative step-off is 1.3 ± 0.4 mm. The average distance between the postoperative and planned articular surfaces is 1.1 ± 0.6 mm as determined in the distance map measurement. There is a tendency to achieve higher accuracy as experience builds up, both on the surgeon's side and on the design engineering side. We believe this technology holds the potential to achieve consistent accuracy of very complex corrections.

 
  • References

  • 1 Colles A. On the fracture of the carpal extremity of the radius. Edinb Med Surg J. 1814;10:181. Clin Orthop Relat Res 2006; 445: 5-7
  • 2 Cooney III WP, Dobyns JH, Linscheid RL. Complications of Colles' fractures. J Bone Joint Surg Am 1980; 62 (4) 613-619
  • 3 Aro HT, Koivunen T. Minor axial shortening of the radius affects outcome of Colles' fracture treatment. J Hand Surg Am 1991; 16 (3) 392-398
  • 4 Knirk JL, Jupiter JB. Intra-articular fractures of the distal end of the radius in young adults. J Bone Joint Surg Am 1986; 68 (5) 647-659
  • 5 Goldfarb CA, Rudzki JR, Catalano LW, Hughes M, Borrelli Jr J. Fifteen-year outcome of displaced intra-articular fractures of the distal radius. J Hand Surg Am 2006; 31 (4) 633-639
  • 6 Fernandez DL. Correction of post-traumatic wrist deformity in adults by osteotomy, bone-grafting, and internal fixation. J Bone Joint Surg Am 1982; 64 (8) 1164-1178
  • 7 Ring D, Prommersberger KJ, González del Pino J, Capomassi M, Slullitel M, Jupiter JB. Corrective osteotomy for intra-articular malunion of the distal part of the radius. J Bone Joint Surg Am 2005; 87 (7) 1503-1509
  • 8 Prommersberger KJ, Van Schoonhoven J, Lanz UB. Outcome after corrective osteotomy for malunited fractures of the distal end of the radius. J Hand Surg Br 2002; 27 (1) 55-60
  • 9 von Campe A, Nagy L, Arbab D, Dumont CE. Corrective osteotomies in malunions of the distal radius: do we get what we planned?. Clin Orthop Relat Res 2006; 450: 179-185
  • 10 Oka K, Murase T, Moritomo H, Goto A, Sugamoto K, Yoshikawa H. Accuracy analysis of three-dimensional bone surface models of the forearm constructed from multidetector computed tomography data. Int J Med Robot 2009; 5 (4) 452-457
  • 11 Dobbe JG, Vroemen JC, Strackee SD, Streekstra GJ. Corrective distal radius osteotomy: including bilateral differences in 3-D planning. Med Biol Eng Comput 2013; 51 (7) 791-797
  • 12 Cole RJ, Bindra RR, Evanoff BA, Gilula LA, Yamaguchi K, Gelberman RH. Radiographic evaluation of osseous displacement following intra-articular fractures of the distal radius: reliability of plain radiography versus computed tomography. J Hand Surg Am 1997; 22 (5) 792-800
  • 13 del Piñal F, García-Bernal FJ, Delgado J, Sanmartín M, Regalado J, Cerezal L. Correction of malunited intra-articular distal radius fractures with an inside-out osteotomy technique. J Hand Surg Am 2006; 31 (6) 1029-1034
  • 14 Dobbe JG, Strackee SD, Schreurs AW , et al. Computer-assisted planning and navigation for corrective distal radius osteotomy, based on pre- and intraoperative imaging. IEEE Trans Biomed Eng 2011; 58 (1) 182-190
  • 15 Jupiter JB, Ruder J, Roth DA. Computer-generated bone models in the planning of osteotomy of multidirectional distal radius malunions. J Hand Surg Am 1992; 17 (3) 406-415
  • 16 Athwal GS, Ellis RE, Small CF, Pichora DR. Computer-assisted distal radius osteotomy. J Hand Surg Am 2003; 28 (6) 951-958
  • 17 Radermacher K, Portheine F, Anton M , et al. Computer assisted orthopaedic surgery with image based individual templates. Clin Orthop Relat Res 1998; (354) 28-38
  • 18 Verstreken K, Van Cleynenbreugel J, Martens K, Marchal G, van Steenberghe D, Suetens P. An image-guided planning system for endosseous oral implants. IEEE Trans Med Imaging 1998; 17 (5) 842-852
  • 19 Vrielinck L, Politis C, Schepers S, Pauwels M, Naert I. Image-based planning and clinical validation of zygoma and pterygoid implant placement in patients with severe bone atrophy using customized drill guides. Preliminary results from a prospective clinical follow-up study. Int J Oral Maxillofac Surg 2003; 32 (1) 7-14
  • 20 Lombardi Jr AV, Berend KR, Adams JB. Patient-specific approach in total knee arthroplasty. Orthopedics 2008; 31 (9) 927-930
  • 21 Van den Broeck J, Wirix-Speetjens R, Vander Sloten J. Preoperative analysis of the stability of fit of a patient-specific surgical guide. Comput Methods Biomech Biomed Engin 2013;
  • 22 Leong NL, Buijze GA, Fu EC, Stockmans F, Jupiter JB. Distal Radius Malunion (DiRaM) collaborative group. Computer-assisted versus non-computer-assisted preoperative planning of corrective osteotomy for extra-articular distal radius malunions: a randomized controlled trial. BMC Musculoskelet Disord 2010; 11: 282